Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: NismoTronic 3.10.002 Update: Launch control switch | ADC Inputs | TCD Compare

+ Reply To Thread
Posts: 11-14 of 14
2014-02-13 15:53:30
#11
Originally Posted by gtswrx
Like TunerPro, it helps even more if the compare function gives you also an option for a difference calculation (like -5 degrees timing in this cell and -2 in the other; 28 more units fuel here and there).

Good work, I don't wanna sound like I'm complaining


The compare difference mode is the next thing on the list for the compare function .. it will also change the text color to red whenever there is a difference in the cell.

I always appreciate suggestions, so if you want to see it .. just ask!
Last edited by JKTUNING on 2014-02-13 at 15-55-29.
2014-02-13 16:28:11
#12
Originally Posted by OnTheChip
Documentation for this is in the works. ADC inputs are already in the triggers list for other outputs/functions. Will have a wiring diagram posted soon.

Dave


I just updated to this version and some outputs only list A/C or PSP switches as the options, unless I am not seeing something:

* BOOST CONTROL > EBC SETUP > HIGH BOOST
* LIMITERS > OTHER REV LIMIT > PROGRAMMABLE LIMITER > ARMING INPUT
* OUTPUTS > MAP SWITCHING > ALTERNATE/SECONDARY MAPS ARMING INPUTS
* GENERIC OUTPUTS > GO1/GO2 ARMING INPUTS
2014-02-13 17:10:18
#13
Originally Posted by gtswrx
Originally Posted by OnTheChip
Documentation for this is in the works. ADC inputs are already in the triggers list for other outputs/functions. Will have a wiring diagram posted soon.

Dave


I just updated to this version and some outputs only list A/C or PSP switches as the options, unless I am not seeing something:

* BOOST CONTROL > EBC SETUP > HIGH BOOST
* LIMITERS > OTHER REV LIMIT > PROGRAMMABLE LIMITER > ARMING INPUT
* OUTPUTS > MAP SWITCHING > ALTERNATE/SECONDARY MAPS ARMING INPUTS
* GENERIC OUTPUTS > GO1/GO2 ARMING INPUTS


That's because the ADC inputs are already listed in the TRIGGERS box.

Dave

Edit: If wired as shown in the diagram above, you would set the ADC ON voltage to 0V and the OFF voltage to 2.5V, or you could reverse the ON/OFF logic by setting the ON voltage to 2.5V and the OFF voltage to 2.0V.
Last edited by OnTheChip on 2014-02-13 at 18-04-46.
2014-02-13 19:04:01
#14
Originally Posted by OnTheChip
Documentation for this is in the works. ADC inputs are already in the triggers list for other outputs/functions. Will have a wiring diagram posted soon.

Dave


I knew it was something that eluded me
Last edited by JKTUNING on 2014-02-13 at 20-29-10.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top