Thread: Feature Request - New Feature Log

Would it be possible to have a indicator light in gauges, or the option to use a unused output to indicate when in closed loop wideband? Would make it easier to setup the ideal closed loop for the best fuel economy.

is there anyway to hookup multiple breakout boxes? we want to be able to run a shit load of gauges to the ecu.

You can check when the engine is in closed loop by watching the O2 Trim values .. an indicator might be possible at some point.



At this time we are limited to 4 ADC inputs, but this might change on the next revision of the NEMU board.

gotta couple quickies for ya..

can you make it so the monitor window aka CTRL+M can be accessed anywhere in the software? what i mean is, i have to be clicked ON the tuning window to open it, other wise ctrl+m dont work and its greyed out.. i use it alot so this has become annoying lol..

another thing i find annoying is the play / record buttons, now, theres 2 sets, one set on the log analyzer and another on the tuning window itself.. what i find happening is i'll be using one on the tuning window then goto use the one on the analyzer, but if both play buttons do not say review log while hovered over with the mouse it can make things confusing.. i've cured my lap top up an down damn near chucked it out the window because of this..


last thing, i cannot get my wideband to connect in SA via USB, not sure why.. i believe i can get it to in RT, i can double check this if need be but im pretty sure.. i went as far as reinstalling drivers, confirming port numbers, tryin different usb ports.. i can see it in the device manager.. i hit connect and nothing happens tho..

Can you explain.... "connect" the wideband in SA?

Its just a wire output from the gauge/controller usually 0-5v to connect to an input channel.

i like to use my usb to dial the 0-5v connection in.. so its spot on ya know.. not to mention the usb always shows what the gauge on the dash shows so its nice to have it to compare to..

is that what you mean?

otherwise to use the 0-5v you goto the setup tab then wideband and check the box an set which adc its set to an what wideband it is.. an viola!

the usb thing i believe you set it settings under direct wideband logging

So you are connecting your wideband output signal directly to your PC/laptop?

usb (from zeitronix box) to laptop and 0-5v to breakout box

I have mentioned this issue quite a while ago. It will not let you connect a wideband via the serial port. Also the voltage offset does not adjust it either. You have to use the point offset which i do not think is as accurate.

I will see what I can do about this.. it is defaulted to this because you need to have a tune window open for the monitor window to open (it needs the RPM and LOAD scales from the main table to populate the monitor window.



You need to be a little more clear on what you mean here. Are you stating that both sets do not have the same mouse over "help tag"?

The state of the button is what is important, if it is pressed it is in review mode .. if it is not pressed it is in log mode.



I am going to try to get on this today .. you can confirm that it works with RT, but right now there seems to be an issue with the connection on the SA version which I need to work out when I get a chance.