Thread: My 4dr B13 Project

I did my swap like a month back a 20v engine and 6 speed tranny if need any pics of the mounts i used custom pm me

Sent from my SM-N920P using Tapatalk

Well yeah but you only need the shifter axles and the specv knuckles

Sent from my SM-N920P using Tapatalk

Got me a Q45 TB







My question here is; what do I do with all those vacuum lines?

Did some wrenching today.

Changed the W/P and Crank pulleys


Changed the clutch kit and flywheel

It's finally in!


I had a few problems though; the bracket for the tranny is incorrect. I need the one that has the BX imprinted on it.


I bolted up the rear engine mount, then this


I unbolted the rear engine mount and bolted up the front, then this


I'm using the following pieces:

• GA16 cross-member (manual)
• SE-R rear engine mount bracket
  

Has anyone had this issue?

Buddy i was just looking on your full post and thread on this from 2010 to now and it has a full life of work on it

Sent from my SM-N920P using Tapatalk

Haven't been updating this thread in a while.

Got the motor mounted in flush


and picked me up one of these


Stay tuned...

UPDATE

Wiring being done.

UPDATE

Some weight reduction
[





Fuel cell installed


ECU mounting plate installed

db was here