Thread: three gauge setup

hey everyone setting up my triple gauge and relocatethe radio. im about to order this right now

42 Draft Designs

my question is thwy hold 52mm gauges i bought these a few months back

http://www.sr20-forum.com/electronics/44509-wi-b14-custom-center-vent-gauge-pod-w-boost-egt-oil-pressure-gauges.html

will they fit fine?
all help is appreciated thank you.

i did search a bit but its frustrating on my droid.

They should fit. The 3 gauge panel you just bought holds 52mm gauges. So if i am reading correctly, you said you bought 52mm gauges. The gauges should fit perfectly into the panel.

no sorry you misunderstood im asking are the gauges i bought 52mm so i could i just order the plate right now.

Ohh i see. I am 90% sure they are 52mm since majority of the autometer gauges ive seen are 52mm. You can measure them and see if the come out to 2 1/16" however if they are slightly bigger, you can probably shave the holes on the plate to make them fit the gauges.

thank you i was confused on maybe my gauge was a bit smaller but thats just what i wanted to hear.

they probably are just measure like someone already suggested. I don't think you are going to get that flush look with those gauges though I think that was just with the VDO vision ones.

Yeah i think rust is right it looks like the vdo were designed to sit flush in the pod holder, even though it will fit any 52 mm gauge because of the bezel being bigger on most of them then is gonna poke out a bit. hey check ebay i seen a couple of them going for a couple dollars less with free shipping