Thread: tsuru h4 harness

thanks tomas, well i didn't finish last night there was a stripped bolt that I didn't want to bother to take out last night
so I'm going to do it today
It's pretty simple once you start

ha done! it was B!

hey now my passenger turning signal won't stay on, it only turns on when I put the signal on.
Any suggestions

^The issue there is due to the fact that the JDM/MDM corners plug only have a ground and signal or positive wire - your choice which to use . Using the Positive wire will have your corners turn on with your accessory lights. Using the signal wire will have your corners work as signals for turning. This is due to the fact that the bulb housing for JDM/MDM corners is 1156 and is a 3 prong housing.

If you look at your US spec signals plug, there are 3 wires, ground, positive & signal. The US spec housing is able to function as both because it uses a 1157 4 prong bulb housing. I believe there's a thread here about shaving off or down on the US 4 prong housing so that it's capable of sliding into and twisting into the JDM/MDM corner. Either you do that or you can do what I did.

Buy 2 amber LED 194 bulbs for the inner part of the TSURU headlight...attach some resistors, bridge the ground of the corners and run the signal wire as the positive and now you have accent lights from the JDM/MDM corners and a turn signal within your headlight.