Thread: What Did You Do To Your B13 Today?

i got her sittin 2" lower to the ground

niceee!


Today I seafoamed my car to see where I have exhaust leaks at and found that the catalytic converter out gasket needs to be changed =\

installed new wheel bearings,Brake pads,front 626 lip,and minor wire tuck..
finally redid my nasty ugly sagging head liner..a piece of cake!
waiting till the end of the month to get all my parts for a fully built VE+T
build consist of=
8,5,1 cp piston,VE head gasket,VE oil/water pump,chain /tensor,manley rods,acl race bearings,ARP main and head studs,Balanced flywheel and 8cw crank,port and polished head,supertech S/R,thermo spacers.......GT30R? maybe

Finished stitch welding the bay, cleaned the welds and filling in holes. Getting ready to finish of the bay!

I finished separating the motor and tranny. Got the motor up on the stand. Also took care of some surface rust on the frame.

Rotated my tires today. Hate the snow.

Wire tuck, you will get a much better idea once the motor is in the car.



Installed the new manifold and put the Tial on. Need to rotate the turbo a little more.

changed the battery and the alternator

Thats a good way to check for leaks.I like that idea.Cleans the engine at the same time,too.Bonus

Drove it to work, home for lunch, back to work and home again. 12 more miles on the clock.

(Ordered a car cover yesterday)