Thread: Any interest? Blox Parallel links...

I double-checked my emails and you're absolutely right. I'll blame it on too much brake pad dust.

I built you a set using the "old" design, which was a 3 piece bushing, in August-ish of 2010.

The "new" design is a 2 piece bushing and is what I was looking to have validated before starting a group buy.

Viperoni... I will be in a position to purchase and validate these if you'd like, but it will be after the convention. Unless you can get the stuff to me in the next two weeks, then it could be before the convention (can send payment today). I will pay before delivery. I plan on getting a baseline alignment spec before install (unless I can find my old print-out) and I will get an alignment immediately after install (if they install well). We can work out a deal as far as information sharing, feedback, and contingency plan if they need work. Keep in mind I do have TurboFX's set in my kitchen right now that I plan on comparing them with. Let me know if I can help.

I appreciate the offer, unfortunately the only set I made is with the person that has them now. I do have all of the measurements/info I need to make more.

Did SE-R_TECH (Ryan) end up with them?

I would be interested to see your new design as I have seen your old design on jimmi's 93 and I would really like a set for my car !

I just made a set of these for fun the other day. they are super beefy with 3/4 inch rod ends and full thread engagement inside the threaded tube. all parts have super durable finishes that will resist rust forever and keep anything from seizing up. spacers still being made at the machine shop and setting up an account with a company that will provide me with dust boots.

I want those for mine.

Looks good JJ

i want a set.

Im goign to be doing a disk conversion to my b12 here in the near future, i had ententions of building a set of these my self, however they would have been quite inferior to these. To my knowledge inorder to properly swap over to a disk hub from ye'ol drum lug longer controll arms are needed. b12 n 13 arm are too short? idk if the two have the same length.

Id be interested in a set in the next coupple of months when i can afford the disk conversion, if we find that none of the current productions are the correct size would you make a set for me?