Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: MAF Voltages (VQ Table)

+ Reply To Thread
Posts: 91-98 of 98
2012-12-31 12:57:49
#91
Yes thats what i am saying. All those maf's are the same. same housing, same element.

They all just use a different VQ table suited to whatever motor/ecu its used in.

Like the N60 maf is used in the old maxima's (VE30E or something) and also the Skyline (RB20DET or something).. same part number, same maf but both vehicles use a different VQ table.
2012-12-31 14:18:58
#92
You can fine tune the VQ table to get your AFRs ironed out too. Heck you can even make your own VQ table if you have enough time on your hand. Having premade VQ table just helps you save a ton of time
2014-06-23 23:31:55
#93
G Spec Performance - Billet MAF Adapter

One of these with an N60 MAF sensor, which VQ table would be best used for a bolt on N/A 2litre VE?

TIA.
2014-06-27 23:45:36
#94
Originally Posted by amdeman
G Spec Performance - Billet MAF Adapter

One of these with an N60 MAF sensor, which VQ table would be best used for a bolt on N/A 2litre VE?

TIA.


my guess would be... the n60 vq table.
2014-11-20 23:10:56
#95
Just a heads up. The spread sheet has the HPX Mas vq table the same as the B13. I don't think that is right. https://spreadsheets.google.com/ccc?key=0Anmiu0rUufw3dExLMFZMNkdkZ2pwdUR0aHZnMkhkeVE&hl=en&authkey=CIyvhsED
2014-11-21 02:14:56
#96
Originally Posted by KillerKrossover
Just a heads up. The spread sheet has the HPX Mas vq table the same as the B13. I don't think that is right. https://spreadsheets.google.com/ccc?key=0Anmiu0rUufw3dExLMFZMNkdkZ2pwdUR0aHZnMkhkeVE&hl=en&authkey=CIyvhsED


Your correct, removed it.
2016-12-04 21:56:15
#97
I'm planning on using this 4" OD MAF Housing with air straightener on the B11, should it be best to start with the N60 VQ Tables too ? Will be using sr20ve Maf, 550cc fuel injectors, 88mm 12:5.1, 100mm BBK TB & 4" piping



Last edited by macakin on 2016-12-04 at 22-09-36.
2016-12-13 14:43:46
#98
I have made a similar setup with the internals of a VVL Maf. I used the Stock VVL VQ as a base, and kept scaling the VQ map till the A/F matched the unmodified MAF readings at particular RPMs. eg: 1000, 3000 and 5000RPM. Hope that helps
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top