Thread: Throttle body spacers

Any interest in these? I would be down for one.. Can't seem to find any existing ones for our motors.. wierd. Anyway I always wanted one and figured I throw the idea out there. I figure by the time interest pops up and you get to make these (if you do) from your long list of products I'll have some $$ scratched up. Lets C

We can do them, no problem at all. Even vortexed inside. It would more than likly run around $100 or so all fully machined.

mark

swweettt thanks for the speedy reply.. alright I'll keep that in mind whenever I have money to spend on something other than bills I'll let you know

Doesn't Outlaw Engineering make spacers? I have set on my car.

Outlaw Engineering

Those are thermoblok spacers... Those go on the intake manifold. Serve a completely different purpose aswell. They sound sick too


http://www.youtube.com/watch?v=vDzF48mb7V4


Sound clip..

http://www.youtube.com/watch?v=CbCLyqvF3VI&feature=related

So what is it actually supposed to do?

A TB spacer is supposed to spiral the air going into the motor. Creating a vortex. So basically think of it this way. Instead of your air going in your motor and bouncing off all the walls of the intake tubes and runners. A TB spacer will make it like a tornado, where it funnels the air in, faster and without any turbulence.

Make sense? i am not sure if it did to me lol.

Mark

yup.... you'll feel better throttle response and a little more low end torque

You know we are going to need dyno sheets before you even make this. You guys also need to get back to me on the pm I sent you. I never recieved a reply.

What are you talking about? Whos we? I'm pretty sure OEM already approved this so WE don't need any dyno sheets. No one is trying to persuade you to buy this it is a request for me. If you dont want one then bye. Its not a header its just a piece of aluminum with a vortex in it nothing made to increase numbers. Please contact them using another method other than polluting my thread. Thanks