Thread: Carbon Fiber Interest

Sounds good. More pics tomorrow with the lip kit on.

Mark

Hack it up in two spots? My 626 lip was a perfect fit as is... with a little heat gun "help".

Can't wait for the CF lip though!!!!

You have to cut it for the nx...a little off each piece in the middle.
I think it fits the sentra without cutting.
So...Mark,you may need 2 different ones

Humm, Well we for sure had to cut it to fit flush all the way around. It was about 2" short on one corner. And the rear section did not fit up flush with the end of the bumper at all it was around 1" to far forward. Either way we can test fit on the NX to check fitment.

Mark

nice get one that works on a nx, and ill buy !!.

stratton.

great progress. Can't wait to see the final product.

I found that the ends line up on the nx,and you have to cut about a half inch off each piece in the middle to make it fit.
On the ser,you are right,it is short by like an inch on the ends.
I will put up some pics of each for you later.

WE will test fit on Eggs car. It looks like maybe Joe has a different front bumper.

The 626 is the right length for an NX bumper, which is shorter than an SE-R bumper. I'm pretty sure that is what Jay is talking about

B13 SE-R 93 front bumper:
Does this look short to you? It's a near perfect fit.
The "gap" in the middle is about 3mm wide.