Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Carbon Fiber Interest

+ Reply To Thread
Posts: 101-110 of 217
2010-04-13 19:41:44
#101
Sounds good. More pics tomorrow with the lip kit on.

Mark
2010-04-13 20:05:41
#102
Originally Posted by Overkill
Nope that the 626 lip. But in order to make it work you have to hack it up in 2 spots. The whole reason we are making a new one and with CF, so it will function correctly and weight in at under 1lb


Hack it up in two spots? My 626 lip was a perfect fit as is... with a little heat gun "help".

Can't wait for the CF lip though!!!!
2010-04-13 20:49:23
#103
Originally Posted by CleanSER
Hack it up in two spots? My 626 lip was a perfect fit as is... with a little heat gun "help".

Can't wait for the CF lip though!!!!


You have to cut it for the nx...a little off each piece in the middle.
I think it fits the sentra without cutting.
So...Mark,you may need 2 different ones
2010-04-13 21:49:00
#104
Humm, Well we for sure had to cut it to fit flush all the way around. It was about 2" short on one corner. And the rear section did not fit up flush with the end of the bumper at all it was around 1" to far forward. Either way we can test fit on the NX to check fitment.

Mark
2010-04-13 21:55:39
#105
nice get one that works on a nx, and ill buy !!.

stratton.
2010-04-13 22:02:59
#106
great progress. Can't wait to see the final product.
2010-04-13 22:13:41
#107
Originally Posted by Overkill
Humm, Well we for sure had to cut it to fit flush all the way around. It was about 2" short on one corner. And the rear section did not fit up flush with the end of the bumper at all it was around 1" to far forward. Either way we can test fit on the NX to check fitment.

Mark


I found that the ends line up on the nx,and you have to cut about a half inch off each piece in the middle to make it fit.
On the ser,you are right,it is short by like an inch on the ends.
I will put up some pics of each for you later.
2010-04-13 22:22:13
#108
WE will test fit on Eggs car. It looks like maybe Joe has a different front bumper.
2010-04-13 23:11:56
#109
The 626 is the right length for an NX bumper, which is shorter than an SE-R bumper. I'm pretty sure that is what Jay is talking about
2010-04-13 23:45:09
#110
Originally Posted by eggman
I found that the ends line up on the nx,and you have to cut about a half inch off each piece in the middle to make it fit.
On the ser,you are right,it is short by like an inch on the ends.
I will put up some pics of each for you later.


B13 SE-R 93 front bumper:
Does this look short to you? It's a near perfect fit.
The "gap" in the middle is about 3mm wide.


+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top