Thread: Tubular front control arms

Is this for the B14?

And FYI, everything continues to look good on the NX. I will get it up on the lift later this week for a closer inspection.

B13 and B14 are same. The bushing for rear is a little different this time. ON your NX it was a little too tight for me personally. This new bushing will allow easier installation while still maintaining stiffness.

Mark

After these two set are built we are more than likely not going to be building another set. Sorry guys but it was apparent that people committed to these if they were to be built but scattered away once they were done. More than likely the only way we will build them again is if there is a group interest with 50% down or you drop your car off at our shop, but will charge install time.

Mark

Mark I do apologize for taking my time, I def still want a set I am just a bit strapped for cash.

Hi Mark,

How many units are you going to produce, I bet there are a lot of people who want to buy them but might be awaiting X-mas to gather enough money for it (including myself).

I think it is the best suspension mod you can do to improve (fix) handling of our cars.

I am building these last 2 sets, 1 set is Joes. Unless a GB gets started or you drop your car off we will no longer be producing anything without money upfront. I love to build these parts for you guys but I have had way to many projects bust because people decide to dip out at the last minute.

Mark

wheres the post with all the pricing info?

Tubular Control arms

Mark I am sending you a PM.

Guys both of these sets are going on my cars. 1 is going on the B14 at the shop, the other is going on my SE-R. Post up in this thread if you are willing to put your money where your mouth is. Mark can build more at this point since he has the blueprint, but I don't blame him for wanting money up front. I have used my gas and time to get cars there for Mark to build this stuff and when the time comes everyone disappears.