Thread: Products Wanted/Needed

Oh, ok I was gonna reverse engineer the factory ones. We wont ruin them though.

Mark

Whatever works better for you guys. Would it make your job easier for me to send mine or would it be easier for you to reverse engineer the stock ones?

It wouldn't hurt. Always helps to see whats been done. I already have a good idea of what they need to be like. What did these run?

Mark

I bought them used in an auction style classified I think I ended up paying a little over 150. They were quite pricey but if we can get these remade for everyone the cost more than justifies the end result.

^this

- I am not a cheap guy and I have a few guys on this forum that can vouch for me, but I will not pay 150 for some window cranks. I'll paint my existing ones and call it a day. How much did they cost from that orginal place?

IDK I wasn't old enough to even get an allowance when these things were new haha . I just bought them and as an afterthought thought I could get them remade if there was enough interest. I know I overpaid for these but I wasn't about to lose them to some person where they would disappear and be forgotten about.

ya they are very rare and thats why they were pricey.. i personally think 150 was cheap for them because of the rareness(if thats a word)..

These will be sent out tomorrow on my lunch break if I remember!

What about just wrapping the stock handles in CF?