Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: What did you do to your NX today?

+ Reply To Thread
Posts: 651-660 of 670
2017-07-05 13:05:04
#651
Originally Posted by hawaiiaNX
Replaced my dashboard, reinstalled my OEM MAF and ECU, and replaced the o-rings on my low pressure line. Going to try a recharge sometime next week.

Branden
Aka hawaiiaNX


Did you replace the drier unit as well?
2017-07-08 22:39:55
#652
Originally Posted by Kyle
Originally Posted by hawaiiaNX
Replaced my dashboard, reinstalled my OEM MAF and ECU, and replaced the o-rings on my low pressure line. Going to try a recharge sometime next week.

Branden
Aka hawaiiaNX


Did you replace the drier unit as well?


I did not actually. I ordered a new one from Rockauto but it did not fit (sensor hole was not threaded), so am going to figure out where to get the correct one from. Just wanted to get everything replaced to see if the system would even hold pressure/vacuum. First step.

If it DOES hold, I will replace the receiver drier and recharge and see if everything will work.

Branden
Aka hawaiiaNX
Last edited by hawaiiaNX on 2017-07-08 at 22-41-10.
2017-07-14 21:27:45
#653
Torqued down the bolts that had come loose on the intake, some weren't even 'hand tight' - whoever installed the thermoblock spacers just didn't seem to think torque was worth it? Anyways, hoping that smooths out my idle issues.
2017-07-17 04:55:13
#654
Took my S4HL's out and swapped back to my stock cams.

Branden
Aka hawaiiaNX
2017-07-21 17:43:16
#655
Fixed the ac system, retrofit, new condenser and drier. Ready for this heat.
2017-07-21 22:10:23
#656
Originally Posted by Ulysses
Fixed the ac system, retrofit, new condenser and drier. Ready for this heat.


Nice! I'm looking forward to getting my AC going as well! Just need to replace drier and can go for a vac and recharge. Not sure if the AC bits are still good though, as the bolt holding the low pressure line into the compressor had been missing since I owned the car, so moisture had a clear path to the internals of the system. Fingers crossed!!!

Branden
Aka hawaiiaNX
2017-07-24 19:53:02
#657
Installed new receiver-drier and Miko tranny saver bracket. Still stock clutch though, so not much difference. Will definitely notice it more with the FX500 when the time comes.

Branden
aka hawaiiaNX
2017-09-15 21:38:29
#658
Wow...dead forum. I added UR Pullies (thanks Kyle) and a splitter/underway that extends 5" beyond the chin spoiler and 14" back underneath the car with a NACA duct for the cold air intake. :-D
2017-09-15 21:44:10
#659
Oh yeah, and ANTIQUE PLATES!!!!
God I'm so old
2017-09-15 22:15:15
#660
Need pics @ian cuz I'm old too!
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top