Thread: Two Wheel Options on the NX2K

tried to photoshop them any one have some good photo shop skills

if you roll out the fenders to make it work that would make it look f**k sweeet

J speed im so tired of OG's everyone and there mother has em'

now if the jspeed was in +25 then yeah

it comes in +38 or +25, Just wondering how much work I would have to do to these to get them to look right, and not like a Juke or something.

i would do +25....would have a more aggressive stance, as long as its dropped a lil...with 205 tires...

Assuming the NX is like the B13 Sentra (and I haven't heard differently) then the 15 x 7 wheels with a +25 offset and 205 wide tire will rub in the rear even if you roll the fenders and have stock ride height. The fronts will be fine though.

The ideal offset for 15 x 7 wheels in the rear is +32 (plus fender rolling). Withouth fender rolling you'd want +38 or so offset. This is for a car lowered about an inch. You can get away with wider settings if you're at stock ride height.

from my experiance with different wheels on my nx...

with agx hypercoils....

17x7 rims,40 offset, 205/50/17 tires didnt rub fenders but rubbed the shocks in back...so i put a 5mm spacer in rear


gr2s and h&r springs...

now i just had on a set of 17x7.5 rims,40 offset, 205/40/17 tires with a 20 mm spacer in the rear...and they rubbed cuz it was too low...now with the agx its a differnt story..


with a 15x7 +25,i would assume you would need to roll the fenders a ll bit,depending on the suspension setup...

My old set up...

16x9 +30 front
16x9 +20 rear

no issues

new set up...

16x9 +25 front
16x9 +15 rear

The fronts were fine, but I had to roll the rears a bit. Oh, I run a 215/40 tire...the most meat I could stuff with minimal stretch.

not really wanting to do 16s or 17s and have rubber bands for tires. I hope I can figure out how to 15 x 8 +25 look good the only way would be with coilovers with camber plates combined with fender rolling and pulling. Just have to figure if I want to do that.