Thread: Transmission bolts

Hey whats up, I'm looking for some bolts for my transmission. I only need 3, the ones that go from the block then to the tranny. Two of them are the botton bolts that go through the block and into the tranny, also i need the one that goes from the engine to the tranny under the bolt that hold the rear mount to the engine. Here is the pic of what I need;


Please let me know the price shipped to 02860 if you can, Thanks

$8.00 shipped.

I will take them! what is your paypal so I can send the money over.

PM sent sir!

Ok, so here is what I may also need, Our transmissions have 2 alignment pins that go into the block and the transmisison slides over them. Chriscar supplied me with a part number 30412-h1001 which i have purchased but it does not look like the one i have in the block already(I cannot remember)
I have supplied a picture of where these pins fit into the bell housing from the engine block, only need one although I have circled both locations where they shoudl be.
The one that is in my block has a rounded head, I think and the one i have from nissan has only a rounded edege but is flat on top..... If you could please possible fine a part number for this that would be great, Thanks again.!

The part number that Chriscar supplied you with is the correct one. All of the dowels that I have seen on the SR20 to the tranny have have a flat top.

Hmmmmmm... I feel dumb, lol
I swear mine haa rounded tip, oh well i might need anothe rone of these when i get my ride back ont he road.
Thank you J for the fast respnses and help!

No problem, that's what I'm here for! Let me know if you need one of those little guys.

Hey J. I was wondering of you had shipped out the bolts yet.. i have not recieved them and have not yet and would like to know the status of them
Thank you
Wes

I'm still waiting on a bolt that I should be receiving today in the afternoon. Once I receive it, you order will go out immediately sir.