Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Question: can I use the MAF wire for Map conversion?

+ Reply To Thread
Posts: 1-5 of 5
2017-01-25 20:59:08
#1
Question: can I use the MAF wire for Map conversion?
Hello guys, planning to move from maf to map. I was wondering if it is possible if i can reuse the wire from maf to be use for MAP?

Also for AIT sensor is there any alternative pin I can use for supply?

thanks
2017-01-26 05:45:04
#2
You can, but.. NismoTronicSA Help - MAP Sensor Installation

As for the iat NismoTronicSA Help - IAT Installation

I'd just do both to the adc box.. I've done a few this way..

Take some time and read through the help documents they have a lot of useful information these guys were nice enough to write up for us, there are some other useful threads here also..
2017-01-26 05:48:41
#3
If your planninto go full speed density I would def take it to someone who's familiar with tuning it and better yet familiar with nismotronic..
2017-02-14 13:25:56
#4
Thanks man yes i already aware on the map installation via ADC box... so that what i'm taking that route.
2017-02-17 23:58:07
#5
Originally Posted by nibbz9999
Thanks man yes i already aware on the map installation via ADC box... so that what i'm taking that route.


You can use the MAF signal and ground wire, but you would need to use the ADC box for the regulated 5 volt source for the MAP sensor anyway.

I HIGHLY suggest wiring everything to the ADC box as this has proven to provide the best and most reliable results.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top