Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Getting EGT Reading

+ Reply To Thread
Posts: 41-45 of 45
2016-11-11 14:51:58
Should be pin 8 on fed emissions.
Last edited by calvin269 on 2016-11-11 at 14-53-55.
2016-11-11 14:55:56
I assume that's the same on the cal Ecu cuz that's what I used. if it was a fed Ecu then the Ecu wouldn't have this input for me to try and be using lol
2016-11-11 15:55:48
With OBD 1 ecu, it was FED. CARB had not come out yet.
2016-11-11 16:57:42
That's weird, when I looked up the Ecu code its listed as a CAL emissions ecu tho. Before I had it chipped I replaced it with a fed Ecu to remove the CEL I got after removing the egr stuff from the egt sensor. I had the CAL one chipped and saved the fed one
2016-11-11 17:10:53
It appears I am wrong. "Two sets, or tiers, of emission standards for light-duty vehicles in the United States were defined as a result of the Clean Air Act Amendments of 1990. The Tier I standard was adopted in 1991 and was phased in from 1994 to 1997. Tier II standards are being phased in from 2004 to 2009." From wiki.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top