Thread: out of memory errors

I am getting "an exception of class outofmemoryexception was not handled" errors when i try to open the gauges. Does any one else get this? I have 2 gb ram @ 35 - 40% being used.

Check your fuses?

sorry , in Nismotronic...fuses are good. this is the Nismotrinic section isn't it?

LMAO

Delete your prefs file in the nismotronic folder, this will pretty much def make the issue go away, you will need to place everything where you like it again. Seems some updates have issues with old prefs files.

When in doubt, delete Prefs.

Nismotronic 101.

thanks, had done that twice. then re-downloaded it re-install seems ok again..

You don't happen to have your old prefs file do you?

It shouldn't have done that unless the prefs file somehow got corrupted. The prefs file and format auto update with each release if there is a change.

Anytime you have an error like this you can email me your runtimeerror report and I can take a peak and see what the issue might be.

ok, not a problem John. I have taken it back out for and will giving it a tune in the next week or so. My EBC was causing a battery drain, so i am going to run that into the ecu and the wideband, oh and swap the vvl pins over from the ve loom. If I get more errors I will forward them onto you.