Thread: driver side bracket issue (6 speed mount kit)

I got an updated bracket from Mark during the SR20 Convention in GA (2013)

The driver side bracket doesn't line up like it should.

Situation 1:
IF the bracket is already bolted to the frame then: It has to be wrestled to get the bolt through mount thats on the trans.

Situation 2:
If you put the bolt through first then: you have to fight the bracket to get the bolts in the frame.


Photos from Situation 2:

I am having the same issue. The actual mount where the bushing goes is also a few degrees off. It should be straight up and down but the top is rolled clockwise a few degrees so the rear bracket you have to fight to get all the bolts in.

I bought my bracket directly from @Mazworx a few months ago.

My setup-
98 200SX w/Prothane mounts

Here is some history...

Sounds like you got old stock... i would definitely call them and get that exchanged

He just bought his recently.

Whenever and for whatever reason...I'd be making contact with Mazworx for resolution.

Yeah that was the point of this thread, I thought they checked their vendor section.

I called Mazworx today because I've been considering ordering this kit. I ask if the motor mount issues in this thread had been corrected. They said they became aware of the thread a couple days ago but no one specifically has contacted them so far.

I got the impression that people are going to have to contact them individually to get this problem resolved.

That is incorrect! Mazworx was made aware in January 2013!

Does Eric still work there? He was my point of contact.
http://www.sr20-forum.com/mazworx/65130-6-speed-swap-kit-issues.html#post905319

I dont know who has been messaging me on FB about this but he said he would show Mark.

He wrote me a few days ago to give me an update with Mark, but said he was sick and would get back with me.