Thread: Mazworx QR 6spd swap kits

Na, I have a line on several of them....

So do you have a driver's side mount for the P12 bellhousing to bolt into a P11?

Brent

We have a QR trans already inspected and have a P12 bellhousing already on it ready for shipping.

Yes we have the mounts available. You will need both mounts to complete the conversion.

nvm..

Was this directed to me? I have a rear P11 mount with the cable shift setup from a Spec V already that fit, I also have the P12 axle carrier bracket so I think all I need is the driver side, unless you think the rear rod style mount is a better option?

Brent

As far as we have tested, the P12 bracket does not work unless you have tried it to work. We've never tried it also with the P11 rear mount so not sure if that works or not either.

But you do know for a fact that the driver side motor mount you have will work on the P11? THis is my main concern as I have everything else and the driver side mount I have mocked up is pretty nasty.

Brent

Cant be 100% sure because its reversed mount unlike the B13/B14

You guys should focus on a P11 option that for sure works, those guys have been all over wanting this much longer than the B13/B14 group has. Not to mention, it is an easier swap so more people would be willing to do it.

Brent

^ good info, i almost bout it for the p11, will wait to see if anyone tested it