Thread: Installing JDM b14 bezel

So i just got around to installing my bezel in my b14
It was very easy but i had to do a bit more than i thought
This process took alittle under an hour

First i started with cutting this bottom piece off

Then you must widen the holes for the clips up top

I started off little by little so that it would be nice and snug when they were wide enough, here is about the amount i cut off to begin with. I used this knife to do the cutting


Change out the hazard clip, the defogger works fine.

This screw on top to tighten it down does not line up, so i made a new hole

And were done

Sweet write-up! I'm still trying to decide on when to get mine.

My middle screw lined up i just changed and cut down the center plastic piece on mine so it sit more flush because it kept trying to push out on mine..


Would of loved to get his wood finished one

Get it man! Its pretty cool to have.
And idk it points up but either way it was higher than the hole. but the advantage with the new hole and why i wanted to do it is because it pulled the bezel up and now it fits perfectly flush on top and all around

And yeah the woodgrain is nuts hahah!

I would really like it if the coin tray was a cupholder instead. but nice writeup though!

Im sure u could come up with something to make it a cup holder.

The coin tray and card holder are both spring loaded, or just the coin tray?

Both.

It has two cup holders, which can be adjusted to small cup or large. I would hate having a cup there because it would seem to be in the way and an annoyance to my eyes while driving. I use the center console anyways for cups.

The card holder and the cup tray are spring loaded its awsome. Im happy with this