Thread: Installing R32 Steering Wheel

Pull out the Horn button using flat screw.




Screw out the 3 screws


Now you can take out the "Back Cover" (set aside)


Screw out again another 3 screws

You can now take out the "back support" (you dont need this)



Get any b13 SW, take out the cover


Screw out the 3 screws,


So you can get the "ADAPTOR"

Place 3 washers to the "Adaptor" so you can fit it to the "Back Cover".


For the horn button to function properly you need this


Insert the other end to the Adaptor

Drill 3 holes at the Back Cover


So you can place the Adaptor

Place washers and screw to bond the Adaptor and Back Cover


Since you have now the "Modified Adaptor"
Place it at the back of the GTR SW,
To function the return signal, ensure that it is perfectly vertical

Screw back the 3 screws


Insert the SW to your car
and insert the other end of the horn button wire.


Screw in the lock for your SW, you can use X wrench.



And finally, place back the GTR horn button.


Now we are done. :melikey:



It maybe apply to other SW.

Thanks!

Happy DIY session....