Thread: How To Make a Leather Shift Boot

This is a Cheap Mod for Those with a Rubber Boot or a Cheap Replacement for Those with the Leather Boot from the Factory..

The Nissan Shift Boots are Really Expensive and all i did was go to a Local Fabric Store and Got some black Vinyl Material with a Semi Gloss to it, it was $9.99 A Yard and it was 50% off of that LOL. the First one took me over 1 hr to make and the 2nd one i made for a friend of mine took me 20 mins. I do have another one i made as well and if you have a sowing machine this mod will take you half the time it took me because i did it by hand..

ill tell you how to do it the best i can in this step by step with photos.

-------------------------------------------------------------------

Does ur shift boot look like this ?



Would you like a new one to replace that old one?





Well now you can and all you need is less then $10 and 30 mins of Time and theses simple Items and Tools





Now you have to Take out ur center Console which is a Few Bolts then Take out the shift Boot which is Easy do not Brake the Plastic Clips Holding it in, you'll have to replace parts on the center console if you do..

Now how do you start, well take a razor blade and cut the old threads holding the two pieces of vinyl together, and it the one holding the metal retainer and pull out the plastic shift knob cap and save everything.

This is what it should look like



Lay the best condition half of the old boot down on the new vinyl material then cut it out and trim it to the size of the original, you can make it a tiny bit wider if you want.











now with both cut its time to sow it together, i lay them on top of each other with the vinyl side facing inward then choose the color string you want, ( red, black, blue which ever )

See the side my hand is on you'll want to sow that area





now see where my hand is now, you will not want to sow that area at all, in fact leave a inch on the sides unsowed so you can tuck it later.





This is where if you have a machine it will go quickly, i did not so i did it all by hand







now both sides done



now if you bent or brake ur metal retainer you can always make one out of a coat hanger







now comes the Plastic shift knob topper piece and theres a rubber band and a metal retainer clip



the Small side will go inside so all you can see on the top is the larger hole



slide the metal retainer over the boot



put in the plastic knob cap piece, with the larger hole facing out



Put the rubber band on first then slide up the metal retainer, there is a Groove that the metal retainer slips into





Now flip the boot inside out so that the black vinyl is on the outside..



Slide ur Metal Boot Retainer in barely so that you can loop over the vinyl to sow it..





now ur Done, here are 2 of them for a b14 i made can it works out the same for a b13 and nx2000



Finish Product