Thread: Engine Hardware Torque Specs

+ Reply To Thread

First

Posts: 31-33 of 33

Search Thread

2012-01-04 07:25:54

#31

ashtonsser Online/offline status of ashtonsser is unknown

SR20VETeran

Join Date: 2007-12-11
Location: Copperas Cove, Tx
Posts: 9,349
Trader Score: 13 (100%)

For the squirters you could just go off a torque chart based on the size of the bolt which is an M10 i believe so roughly about 10-12 ft lbs more than likely.

0 Likes

Be the first to like this post.

1992 Nissan Sentra SE-R - Fully Built SR20VE, BWS400SX Billet 67mm and much more
JMS Racing tuned to 716whp, 423wtq at 29psi
10.5 @ 149.2mph to date I believe the fastest trap speed SE-R, Much more to come with some changes!

Reply Reply With Quote

2012-01-06 03:17:50

#32

chapnutz1

Banned

Join Date: 2009-08-30
Location: loserville fall river MA
Posts: 2,980
Trader Score: 32 (100%)

Main Bearings
tighten to 24-28 ft-lb, then tighten to 54-61 ft-lb

this apply to VE blocks as well

0 Likes

Be the first to like this post.

counting down the days till Ohio, no car just mayhem......

Reply Reply With Quote

2013-03-01 03:15:32

#33

Matej

Member

Join Date: 2013-02-07
Location: Kansas City
Posts: 137
Trader Score: 7 (100%)

Is it recommended to use Loctite or some sort of sealant on any of the bolts mentioned above?
In my case, I am specifically curious about main bolts, cam cap bolts, and cam sprocket bolts.
Thank you.

0 Likes

Be the first to like this post.

Irony.cc

Reply Reply With Quote

First

+ Reply To Thread

Thread Information

There are currently ? users browsing this thread. (? members & ? guests)
StubUserName