Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Engine Hardware Torque Specs

+ Reply To Thread
Posts: 31-33 of 33
2012-01-04 07:25:54
#31
For the squirters you could just go off a torque chart based on the size of the bolt which is an M10 i believe so roughly about 10-12 ft lbs more than likely.
2012-01-06 03:17:50
#32
Main Bearings
tighten to 24-28 ft-lb, then tighten to 54-61 ft-lb

this apply to VE blocks as well
2013-03-01 03:15:32
#33
Is it recommended to use Loctite or some sort of sealant on any of the bolts mentioned above?
In my case, I am specifically curious about main bolts, cam cap bolts, and cam sprocket bolts.
Thank you.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top