Thread: My wiring project

looks good man. Nice job on the harness

Thanks

Ive learned a bunch about what id need to be happier with it, if i ever redo it. Its not perfect but it will work.

Definitely need adhesive lined heat shrink on the sleeving next time.
Definitely need a higher shrink ratio next time, so I wont have to pin everything to get it the way I would like (even though I didnt de-pin this time)
Definitely get smaller sleeving for most wires
Also i should of used non-split loom

I'll see if I can pull em out of my Z pile (not realy a pile more like a shelving unit) of crap. Funny I went from a garage full of Z32 and S30 stuff to almost nothing in about 2 years.

Yes i've been running EMS for about 1.5 years.
I found the base maps that are included with the software, are in the installation folder.


I have also discovered that the coilpacks wont sit down far enough in the VE valve cover to use them with out a 20v cover.

So besides that and changing my ems settings for 4 coils, i have to trim the ground wires to length.

I was wondering what VC to use.. guess 20v is it then..

Gotta pic on the cam sensor with part number?

You want a picture of my distributor?

I thought you will be running a cam sensor instead of a dist.. So you're just using your dizzy?

yeah it has a CAS built-in.

Looking good man! Oh and the dude that has the S15 coil harnesses, you need to be beaten with wet noodles!

Brent