Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: 92' NX2000 auto to stick. Manual engine harness questions.

+ Reply To Thread
Posts: 1-2 of 2
2010-10-01 02:13:36
#1
92' NX2000 auto to stick. Manual engine harness questions.
I just swapped a lowport engine and did a auto to stick conversion. I got my hands on a 91 manual engine harness.

I know that if I was going to use the auto engine harness I'm supposed to jump the inhibitor but I'm not using the auto engine harness so no inhibitor.

So my question is what do I do to get my car started? What wires do I need to jump?

All my wiring inside the car and in the engine bay are from the automatic. The engine harness is the only thing from a manual car besides the manual ecu I'm using.

Hope one of the wiring guru's can help me out.
2010-10-03 22:32:57
#2
Nevermind figured it out. The wire from the starter which is Black/Yellow on the manual harness was leading to the 2 plug harness that's above the transmission where those 3 plugs on that bracket goes. The only thing was the wires were reversed on the manual transmission so I just repinned it and now it cranks.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top