B14 projector retrofit
Well started out with a used set of lights. And seeing that my car is down and the weather sucks I decided to start on these a little. So far the lights are apart and I completely sanded the inside reflector area along with with the out side. Cleaned both inside and outside and painted with primer.
Main issue I has was that the form area of the mold where the reflector for the OEM bulb was, was touching the bottom of the projector a little. I felt that this was going to cause the projector to not sit completely the way it was intended. So I went ahead and cut it out. I also had some left over fiberglass board from my last job. So I cut it and adhered it with some epoxy. Once it's cured I will sand it down. And re paint it. You won't even notice it.
I will update more as I will be able to get out side and finish it.
Main issue I has was that the form area of the mold where the reflector for the OEM bulb was, was touching the bottom of the projector a little. I felt that this was going to cause the projector to not sit completely the way it was intended. So I went ahead and cut it out. I also had some left over fiberglass board from my last job. So I cut it and adhered it with some epoxy. Once it's cured I will sand it down. And re paint it. You won't even notice it.
I will update more as I will be able to get out side and finish it.