Thread: Need help to mate a VVL head to Pulsar block

I have a GTIR Pulsar bottom end that I want to install a neo VVL head on to it. My question in this project is the headstuds, what headstuds i should use and what else is needed to be done in order for the head to mate to the GTiR bottom end?

gtir studs need to drill bigger holes on vvl head to match size


Sent From iphone Tapatalk

also i think you need to either drill and tap, or run a new line for the OIL for the VE head

Thanks

Most importantly, you need to drill out the VE dowel pin holes on the head to match the GTIR to avoid the gasket shift. Even though the 12mm stock GTIR studs will pass the VE head it still needs to go +1mm .

intake manifold, will work with some customizations.

has anyone had a good documentation or like pics that have done this before. that would be much helpful to those who want to upgrade their gtir on vvl head.