Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Madtec's Pulsar update...

+ Reply To Thread
Posts: 21-30 of 160
2012-08-02 16:56:04
#21
Yea, i have seen those before, they are almost $100 bucks a piece....
2012-08-11 22:20:11
#22
Steering Rack and Front control arm (rear bushings)
Last edited by Madtec on 2012-09-18 at 19-02-43.
2012-08-12 05:00:14
#23
SuperPro koozie. Nice
2012-08-29 03:38:43
#24
Took some pics a while back of the gunk build up on the valves using my inspection camera





2012-08-30 00:28:01
#25
Main engine harness out and ready to be re-done

Braided sleeving, wire tie and shrink wraps are in (shrink wrap not shown)

Started stripping off the old convoluted tubing and electrical tape

Almost complete

Amature night-previous owner



All this from the engine harness

More updates later this week....4-day weekend woohoo
2012-08-30 01:14:19
#26
Good stuff on the update.

Seeing all of that wiring gives me the creeps for sure! I am horrible with wiring stuff and other electronics.

Good luck, sir. I know you will get it done the right way!

Richard says hello to you and your youngster!
2012-08-30 02:42:10
#27
same way i did i full pull out, car felt much better after - i just now need the loom section, for the O2 sensor
2012-09-18 18:58:57
#28
Busy few weeks, but this came in yesterday....
2012-09-18 19:15:50
#29
Got a chance to clean the engine bay as well...
before...

after...
2012-09-18 19:55:34
#30
You must work in aviation
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top