Thread: Need help with clutch install: shifter is wrong position ?

So what do I win?

Also, if the trans is missing the dowel/guide pin in the case this can lead to bad JooJoo ... but it sounds like your issue has been resolved theoretically

Sorry, I said it first but...

Sorry but u said something was out of alignment, which was quite obvious, I called the bolts being the issue, if that is indeed the issue..

I mentioned it in texts before this thread was created. However, you can have the prize though, I got a cheese steak and a bunch of beers out of the deal.

Haha you guys..

Ok so I realigned the rear mount bracket and inserted the missing long 14mmbolt, the shifter was in the correct place and the car drove fine around the block in gears 1-3 but still felt a little "loose" - and that's prob because there is one short 14mm bolt that I can't find where it goes

It goes in the hole, inside of the hole.. I know it's hard to get your ahead in there to see it..

Hmm. I just texted Ray Kawski and he said "The short 14 goes inside the motor mount at rear."

I'll keep looking, thanks Lynch

There is a round hole inside the oval hole

Here is an example


http://s160.photobucket.com/user/shigspeed/media/G20%20Forum/G%20VE%20Swap/DSCF9422.jpg.html