Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Chamfer oil holes in crankshaft?

+ Reply To Thread
Posts: 1-4 of 4
2016-10-08 10:08:25
Chamfer oil holes in crankshaft?
Does anyone chamfer the oiling holes on their sr20 factory cranks? I see mazworx doing it on their cranks and lots of other doing that too... Just unsure if I should or if anyone with a high power motor has had this done.

It's for an sr20vet rwd build, power wise 500-600hp. Yes, the sr20vet oil pump will be used so i'm expecting higher oil pressures than regular sr20's.


Drag v8's:

If YES, did u apply it on the mains or the big ends as well?
Last edited by Speedingmofa on 2016-10-08 at 10-09-32.
2016-10-13 11:43:02
It's a nice touch. It should help. I've never actually done it myself though, so I can't help much. =/
2016-10-15 10:27:03
Well i was hoping some response from the big power VE guys, but alright. If no one is doing it on their VE builds and they seem to do fine, I don't see much of a reason to do it on mine.
I'll keep it stock and send it out as is to the machinist
2016-10-15 12:52:44
I think most if not all of the big boy VE Builds left here or the engine has left our realm of existence.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top