Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: designated relay for fuel pump

+ Reply To Thread
Posts: 1-10 of 25
2015-02-08 21:40:14
#1
designated relay for fuel pump
I have been searching and theres not alot to be found concerning this.
I understand the basics of it and relays,etc.
But I am looking at ideas on how to do this most reliably,cleanly and simple.

Show me what ya got
2015-02-08 22:48:13
#2
This was pretty common in the Mitsubishi scene. Its basically supplying battery voltage to the pump. Meaning the fuel pump will get unmetered voltage therefore increasing fuel pressure.

I'll draw up a schematic for you in a bit. Super easy to do.

Check this out.
http://www.enginebasics.com/Advanced%20Engine%20Tuning/Images/Fuel%20Pump%20Relay.gif
Last edited by ebinkerd on 2015-02-08 at 23-07-46.
2015-02-11 18:26:03
#3
85 - factory fuel pump positive signal
86 - ground
87 - fuel pump positive output
30 - 14-12 AWG positive wire to the battery
2015-02-13 19:06:24
#4
I did this years ago.
2015-02-13 19:48:00
#5
is this necessary with Walbro fuel pumps as well?
2015-02-13 19:52:25
#6
Necessary? No. Useful? Yes.
2015-02-13 21:21:45
#7
My AFRs changed a lot when i upgraded the wiring. I would say it should be done on any car with mods to make sure you are getting good voltage to the pump.
2015-02-13 22:03:04
#8
Would you think its necessary On a stock det swap with 370s stock maf n walboro pump?or any boosted application
2015-02-14 01:43:35
#9
Originally Posted by squirlz
85 - factory fuel pump positive signal
86 - ground
87 - fuel pump positive output
30 - 14-12 AWG positive wire to the battery


Thanks that was what I did
Turned out great...heres some pics and details of the install.
I will do this to any/every time from now on.Even on a stock pump,I would bet it makes a difference.

http://www.sr20-forum.com/sentra-se-r/39341-what-did-you-do-your-b13-today-90.html#post1012718
2015-02-14 02:02:38
#10
Originally Posted by eggman
Originally Posted by squirlz
85 - factory fuel pump positive signal
86 - ground
87 - fuel pump positive output
30 - 14-12 AWG positive wire to the battery


Thanks that was what I did
Turned out great...heres some pics and details of the install.
I will do this to any/every time from now on.Even on a stock pump,I would bet it makes a difference.

http://www.sr20-forum.com/sentra-se-r/39341-what-did-you-do-your-b13-today-90.html#post1012718


As always Jay, excellent work!
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top