Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Would anyone be interested in solid aluminum motor mounts?

+ Reply To Thread
Posts: 21-27 of 27
2015-03-13 14:47:04
#21
Took some time due to weather being cold as f**k. I should have the finish products by Monday/Tuesday

2015-03-13 15:46:11
#22
^ looks like you are going the same route we did (post #13).... We've been using ours since 2008 FWIW HOWEVER we ONLY have the crossmember front and rear solid aluminum and left the rest factory rubber (meaning the passenger and trans mount are NOT solid)
2015-03-13 16:29:06
#23
Yeah Chris I took that page from your book. I'm making these for the pass & trans for mines since I have no CM
2015-03-13 16:57:31
#24
Originally Posted by Dave_SR20
Yeah Chris I took that page from your book. I'm making these for the pass & trans for mines since I have no CM


Wait, you have no crossmember? ...so your engine is being held up by 1 motor mount and 1 trans mount ONLY? What happened to your crossmember?
2015-03-13 17:23:59
#25
I have a bar/tube that runs from side to side on the back of the chassis then there's a brace that bolts on that bar to the motor that anchors the motor from back and forward movements.
2015-03-13 17:25:51
#26



2015-03-14 13:33:45
#27
Nice work.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top