Thread: Does anyone make an EGR delete kit anymore?

I've tried searching but came up empty handed.
The only kit i found was from Nissport but it appears they are no longer making these.
Does anyone know where I can get one for a highport?

Hmmm, I made my own, but I think someone like Custom Steel must still make one. I bet if you give Greg V at Gspec a call he probably carries them.

How did you make your own?? Is there a thread?

I pulled off the two EGR flanges and traced them onto 1/8 inch thick aluminum. Drilled the holes and cut them out with a jigsaw or something stupid, then I smoothed out the edges with an angle grinder until they were just right. This was a bit of a PITA though because the block off flanges don't have much room between the gaping holes in the manifold and the edge of the flange surface. I made gaskets with electrical tape and bolted them down, they've been on for 3-4 years.

Oh, and I couldnt get the EGR tube out of the stock header so I cut it off and welded it shut.

Ya I've heard about this issue. Mine is pretty damn rusty I think I'll have to do the same thing :/

I did it in the car with a flux-core splatter welder and no mask (I just aimed and turned my head)... it's pretty funny looking but I got it sealed up, I should probably post a pic in that "Ghetto fix" thread

[IMG[/IMG]

Are you selling this as a kit?

Made it the other for my car. Not selling as a kit

loren makes them (DMSentra) on the g20.net