Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Any ideas on WTF happened? CM FX500

+ Reply To Thread
Posts: 31-35 of 35
2016-08-07 15:31:56
#31
Originally Posted by TRACKFORGED
Well was driving the other day, 5th gear, 45mph, downhill coasting, heard a snap and then free rev. Pulled my transmission tonight and found this inside.

B13 w/ 6spd conversion
Clutchmasters FX500 unsprung







EXACT same thing just happenned to me except I was on flat ground in 5th,and didnt hear or feal anything,just started to free-rev.
Clutch was installed for about 150 miles(previously broken in before the engine was replaced,ut still looked new)

Trying to decide wheterto get another disc(maybe sprung) and keep the pp or what

My pics are IDENTICAL to these...
2016-08-08 00:14:13
#32
Wtf this happened to ya recently, @eggman?
2016-08-08 12:34:13
#33
Originally Posted by Kyle
Wtf this happened to ya recently, @eggman?


last week after about 150 miles since install
2016-08-09 21:43:30
#34
aint that some shit
2016-08-11 02:32:40
#35
We had a F350 with a 6speed swap that did that to 2 disk. On the third disk we noticed at the top of the bellhousing was some spots that were rubbing something. The block had a cam cover that was causing a very slight misalignment. We ground the edge off and been no problems since. Since you have done a swap make sure there is not something holding off the bellhousing.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top