Thread: Need help/advise with hydro clutch install

You need to make a bracket then. If you leave the spacer in place, the clutch pedal will be much higher than the brake pedal. If you use the clutch switch to adjust it down, I don't think there is enough movement left. I'm not using the top bolt, only the 2 that connect to the MC, and the one that faces forward.

Where is the one thats facing forward? I'm only using the 2 bolts that that attaches the master cylinder and my top bolt doesnt line up I have a 97 maxima clutch pedal and master.

No, the top bolt will not line up with any of the pedals. You have to do custom brackets for each different pedal setup. Look at Manny's setup, my setup, and others setups. The maxima pedal is the easiest by far because you dont have to drill new holes in the firewall to mount the pedal in the right position. I would go maxima pedal vs any other ones. My modified b15 one hasnt had any issues yet so im sticking with it.

Really? Cause when I was doing my research on the forums everybody swore that the maxima pedal bolts up 100% including the top bolt. Glad to know I'm not going crazy cause my shit is off lol it still feels pretty firm with only the 2 master cylinder bolts though.

I think it depends on chassis. I know on the b14's ive seen soo far it does not line up....On a b13 ive heard it does line up...Soo much different information out there. I know the top bolt on the maxima pedal Manny used doesnt even face upwards it faces horizontal so there is no way it would line up with neither the b13 or b14. Not sure if there is another year maxima pedal people are using that has the bolt setup that the b13/b14 use. All i know is that the one Manny used in the writeup does not and will not bolt directly on the top bolt on neither the b13/b14. Im thinking there is a different year pedal that others have used.

This is something that needs to be clarified soon to avoid confusion.

The maxima pedal has two "top" bolts.
one on the side, the other on the "back"

edit////
I got the bolt in the side spot on my Max pedal (with the firewall spacer still in there)

I'm about to run in the garage and look into this right now lol be right back

.......................................................................\/ side ........\/ top

When you got the side bolt in, did it pull the pedal side bolt hole up tight against the top mounting point on your B13 or, do you think you'll need a few washers to get it to sit flush?

I went to the junk yard yesterday and put a Altima pedal into a B13 there. The side bolt hole on the pedal wouldn't sit flush with mounting hole on the B13.
I suppose someone could use a Altima pedal on a B13 if that's all they had.

I brought home the pedals from a 95 Maxima, a 98 Altima and a 92 B13 for comparison. The Maxima pedal look to be a better choice for a B13. I just think the whole extension welded on the front, for the top bolt hole, should be cut off.

From what I could tell it was flush, but my dash is intact and im not that flexible getting under the dash, so it may not be.