Thread: WTF? Passenger side axle mount...

EDIT:

Did an advanced search on the other site, and found the answer. Didn't have it here.

Question was: DET block and DE mounts. Especially the DE pass. axle mount. Cannot get a clear idea how it mounts.

Answer for archival purposes: Use the DE mount. Only two holes line up, which is fine. The lower 3rd hole is not used.

ass i could have told you that lol

Shaddap Jenny!

It was early, and I was just going thru and putting some things on the motor. I think I may drop it in with everything minus the cams and valvecover. Still waiting on the shim kit. Hell I haven't even received the LCA's or tie rod ends yet.

im pretty much lost......

Torque it to spec, if not the bolt will snap and then you only have 1 remaining.

hmmm.. ok lol.. its all good glad you aint call my ass early cause i got back from the damn club at 4 in the mourning i would have killed you lol

My initial question was WTF I should do because I'm putting a DET block in the car, where it used to be a DE.

The passenger side axle mount on the back of the block doesn't line up on the DET block, vs. the DE block.

Then after doing some more searching on the other forum, I found that you can only bolt it up to two of the three bolts, on the DET block.