Thread: Clutch Pedal

Just finished installing a clutch in my b14. Everythings bolted in and its filled with fluid but the pedal is sticking to the floor when its depressed. Any suggestions on what it could be?

clutch cable not adjusted right or your tob popped off the clutch arm.

Did you convert your set up to a hydrolic clutch? If so, you probably need to bleed the slave cylinder.

Nope its cable driven. Car starts and everything. When the cars off, itll go in gear but the pedal wont come up, when the cars on, it wont go into gear at all. any ideas?

This^

starting to think its the tob but idk how it could have popped off w/ new clips

did you lube the input shaft? the tob can travel past the end of the input shaft and get stuck. I have had it happen to me before. the tob will still be connected to the arm but will not retract due to it going to far on the input shaft.

easil...if you moved the arm at all before it was full bolted up...

i did the same thing "testing"" the throw on my arm when i converted the p10 to hydro

Clutch cable was the issue. The clutch cable bracket was mounted up to far giving the cable too much slack. Stupid mistake on my part. Thanks for the help though guys.