Thread: B13 e- b13 ser

Making a b13 e into a turbo ser. Can't seem to start the car tho. Car will sart if I jump the starter to the battery but not by key. I replaced both bay harnesses with the ser. And dash will light up but not starter. Any suggestions?

Do you have all your grounds in place?

Will it crank at all? If not,see if the little rubber plug fell off the clutch pedal.It's what hits the switch below the pedal,and they tend to fall off.

^ Yeah it's prob the clutch inbt switch. Bypass and try again

No I just tried this. Clutch switch not the issue. I have power to the starter but no signal.

Ohm the wire in section then. Did you try to wire tuck ?

no i have not tried to perform a wire tuck. does anyone know what components/ wires are in the ignition cercuit ill do a search as well. anyone have any ideas other than the previously stated

Found out that I seemed to have lost the plug connected that goes from the driver side harness to the starter. Made my own harness. Works fine. Went back to n/a car seems to run perfectly fine now.