Thread: How to install a Clutch and pedal (Auto to Manual)b13

nobody failed to mention about the clutch switch wiring that might have to be add. do I have to add it or use the cruise switch plug into the clutch plug or what?

I used a Manual SR harness when i did mine. If you are using the auto harness you really do not need a switch on the clutch. You do need to disable the neutral safety switch on the auto harness for it to start. All the factory clutch switch does is make sure the clutch is pressed in when you start the car.

Yep, all you do is splice two wires together on the harness for the switch and you can start it. I dont know the wire colors on the b13, just the b14.

Are ya talking about the Engine harness or the wiring under the dash? My car is automatic, I put SR manual engine harness on the VE, is that a issue? Let me know. If I have to add it, I might need some help on that.

The neutral safety switch i believe in on the tranny. Not positive though.

I will check it out later, its too cold outside! Ahhh, it should not be on the tranny. since it is manual tranny I got in the car. maybe somewhere in the body, will check the book for ref on the location. MMM

It was on the auto tranny, not the new one. So there should be a wire or harness that plugged into the auto that has no where to go now.

Yeah i checked the info, it is on the auto tranny. seem pointless when my tranny is MT, will go to salvage yard to yank the clutch switch wiring out.
Jer 760, if ya know where the wire to splice into. I would like the info or some help if ya can. thanks

How close do you live again?

Well, if ya live in arlington, then you are about 12 mins away from me. I am at NRH Area. I will let ya know when I get the wiring.