Thread: ICHIBA extended wheel studs?

i found some ichiba extended wheel studs for nissan but im guessing these should fit b13 too since i remember that b13 thread pattern is 12x1.25 but the knurl is for oem b13 is 14.3 and these are 14.25. you guys think it fit or not?

here the specification of the extended studs:

Thread Size: 12x1.25

Threaded length approx.: 55mm

OEM KNURL Diameter/Height: 14.25mm/7.5mm


here the pictures

fit or no fit?

im not sure about .05 differance...but if its holding my wheels on...it had better be the right size.....this is coming from a guy who had a wheel stub break completely of and the front left became a horrible vibrating mess...


get the right size.

i think most guys get the arp studs for a wrx or some shit...

Get the arp!

Why do you need extended studs? Wheel spacers?

open up...here comes the spoon...jk


http://www.sr20-forum.com/general-sr20/17199-extended-wheel-studs.html

http://www.sr20-forum.com/suspension/13333-arp-extended-studs.html


http://www.sr20-forum.com/suspension/44478-extended-lugs.html

http://www.sr20-forum.com/g-spec-performance/52962-arp-wheel-studs.html

http://www.sr20-forum.com/sentra-se-r/41756-extended-wheel-studs.html

http://www.sr20-forum.com/general-sr20/43202-extended-lug-nuts.html

no fit, go to ichiba's website and they have a listing with the correct kd only problem is that they are not all that long, I'd guess they would max with a 10mm spacer

If these are going into a fresh hub, they will work. If they are going into a hub that have already had 14.3mm knurl studs pressed into them, the fitment may be slightly compromised.

ARP has nipples. Go with the nipples.

If you go with the arp wrx studs wich i have they are 12x1.25 so nissan lugs nuts will fit . Just throwing this in there.