Thread: Bolts to use on engine stand?

So I went to the junkyard yesterday and picked up some tranny bolts. I'm gonna go to home depot today. How much longer should I get them?

I found 2 other good pics:

Just got off the phone with Greg for my pending order for control arms and whatnot.

He states that he used 10x1.75 bolts that are about 4in. in length, or thereabouts.

Going to home depot or something today to pick some up

damnitt! i reset my block on the stand this morning. i should have measured them. but yes, they are 4" or so long.

just get a bunch of washers as well in case they are too long. I would also recommend getting some fogging oil. After i cleaned evrything, i sprayed fogging oil on any bare metal parts so they have a thin film of oil to keep from flash rusting, or paint them.

10x1.75 are to thin though.

I went to home depot and didnt find anything. But I did find the size with size chart. So i ended up at Osh. They had a better selection, but they dont have the little sizing chart.

Since I had some tranny bolts I picked up from the junkyard. It helped out alot. I found the last 2 packs of the same size bolts.

Size: M12x90 Pitch 1.75

it's almost 4in. long. I also tried them on my spare motor thats sitting in the garage. They fit right in.