Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Interchangable hubs

+ Reply To Thread
Posts: 11-16 of 16
2011-12-05 01:01:34
#11
Does the driver side axel have the balancer in the middle?
2011-12-05 10:40:44
#12
Originally Posted by Ulysses
Does the driver side axel have the balancer in the middle?


Yes balancer is in the middle of drive shaft. All these problems are becoming too much for me, I am getting just plain aggravated now the brake pads I just picked up are too big for the calipers, the current pads are 4 1/2 inches long and the now pads are 5 inches.
2011-12-05 11:28:37
#13
I think Nissanboi meant that it might be the inside bearing and to also check the other side as a precaution. Esp since the driver side is going out.
2011-12-05 14:00:30
#14
Originally Posted by morgans432
the best is when the hub falls out of the knuckle when you take it off


This happened to mine a little while back. Went ahead and replaced everything.(new hub, bearing, and seals)
2011-12-05 16:25:17
#15
Have you checked the carrier/center support bearing on the passenger side? Mine made some noise and vibrations before, and it sounded like it was coming from the driver's side, or in between the driver side and center.

May not be it, but could still be worth checking.
2011-12-05 22:49:42
#16
Originally Posted by NightStalker
Have you checked the carrier/center support bearing on the passenger side? Mine made some noise and vibrations before, and it sounded like it was coming from the driver's side, or in between the driver side and center.

May not be it, but could still be worth checking.


I will check that nightstalk.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top