Thread: wheel bearing/steering knuckle

We found out i have a bad wheel bearing on my NX2k, and we were wondering if it is possible to swap out the knuckle assembly from a GA car or if the splines for the axle on the knuckle are the same as a sr car ?

while asking questions i have another question, my car wont idle right, we had it idling good earlier then took it out for a drive and came back and isnt idling and wants to die, we have checked the TPS, checked for Vac leaks, has new plugs.
ANdy

The axles are different, but the hub/steering knuckle assembly is the same.

ok thanks, that is what i thought, any ideas for fixing the idle, it will idle cold but once it warms up it will not want to idle at all just dies out

check the aac valve, pcv valve, and how is your coolant levels?

how would you go about checkin the aac valve, just resistance readings or what?

What about other chassis? anyone know if the b14 GXE sentra knuckles fit a b14 ser?
if so that would save me a lot of time.

i imagine they do. i swapped a sr into my 200sx base model and never swapped the hubs or spindles.

You can use B14 knuckles in a B13. I have a B14 SE-R knuckle on the driver side of my B13.

i've heard the egr block off helps alot of times.... sounds like u have a classic case of the b13 bog

the car has a JDM intake manifold with no EGR, we hooked up a consult to it tonight, and were trying to open and close the iacv with that and it didnt seem to do much so we pulled it apart and it was clogged with some kind of lint, we cleaned it out, and put it back together it idles now but it idles around 1400, we think maybe now we have a AAC problem we will look at that this weekend but atleast now it idles, and im gonna try and get a knuckle off another car tommorrow and start driving it again