Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: BYTCH Don Come Out!

+ Reply To Thread
Posts: 1-7 of 7
2011-03-02 00:50:26
#1
BYTCH Don Come Out!
Speed Sensor

I took the bolt out. Sprayed it with PB Blaster. Tried to move it around but didn't move an inch. I screwed an axle bolt onto it to grip it better and ended up breaking it. I've changed plenty of B13 speed sensors and never had this problem. What now?


2011-03-02 00:56:03
#2
Brake out a little propane tourch but dont heat it up too much as it has a plastic gear on both the diff and the sensor . G/L
2011-03-02 00:56:47
#3
i usually drive a pointed screw down in the sensor.. and grip the screw. only did it once and cant remember if the sensor was usable so do it at ur own risk lol. also try gripping it with a vice grip.
2011-03-02 01:29:41
#4
Originally Posted by tsuruser
Brake out a little propane tourch but dont heat it up too much as it has a plastic gear on both the diff and the sensor . G/L


I used the propane torch and the whole threaded part broke off. I wonder if there's a way to push the sensor from inside?

Originally Posted by b13fever
i usually drive a pointed screw down in the sensor.. and grip the screw. only did it once and cant remember if the sensor was usable so do it at ur own risk lol. also try gripping it with a vice grip.


The sensor doesn't work so I'll try this method tomorrow.
2011-03-02 03:16:31
#5
Originally Posted by b13fever
i usually drive a pointed screw down in the sensor.. and grip the screw. only did it once and cant remember if the sensor was usable so do it at ur own risk lol. also try gripping it with a vice grip.


I had to do this before.Carefully put a long screw in it and you can pull it with a claw hammer.
Just like pulling a nail.
2011-03-02 03:20:31
#6
Originally Posted by eggman
I had to do this before.Carefully put a long screw in it and you can pull it with a claw hammer.
Just like pulling a nail.


Cool can't wait to try it tomorrow and see what else I break
2011-03-02 06:56:06
#7
Originally Posted by eggman
I had to do this before.Carefully put a long screw in it and you can pull it with a claw hammer.
Just like pulling a nail.


Did it like this aswell
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top