Thread: Air Filter Question - Interest

Standard JWT Filter element is.


Flange ID (a3) : 6
Flange Height (a4) : .8
Top Width (a1) : 5.25
Pleat Height (a8) : .5
Type of Flange (a9) : Traditional
********Element Height (l) : 5***********
Base Width (a6) : 7.5
Type of Top (a10) : Power Stack: Black Rim
Type of Media (a11) : Cleanable, 8-Layer Cotton (Red Oil)


New Filter to be made to fit onto JWT aluminum Velocity stack.

Flange ID (a3) : 6
Flange Height (a4) : 1.75
Top Width (a1) : 5.25
Pleat Height (a8) : .5
Type of Flange (a9) : Traditional
*******Element Height (l) : 7**********
Base Width (a6) : 7.5
Type of Top (a10) : Power Stack: Black Rim
Type of Media (a11) : Cleanable, 8-Layer Cotton (Red Oil)


Filter would be made by S&B filters.


The change to the filter would be the height. The JWT filter is 5 inches tall and the new filter would be 7 inches tall. That would be about 35-40 % increase in filtration area.

Benefit to this would be more WHP on a given filter. The motor would not have to work as hard in the higher WHP-RPMs to make power.

I need to have a minimum of 10 filters made to get this going.

Just asking who would be intrested at a price of $35 each plus shipping.

If there is enough intrest I will start a group buy thread on it. The turn around time would be 2-3 weeks.

Thanks Andreas Miko

Blue media color still? Or S&B's common red?
I will commit if blue. If red I'll have to think about it.

We are going for red.

Tempted, but don't know if I would have enough space for one

just look at your JWT and it woulf be 2 inches longer

x2..

That's what she said.

I'd be interested in 2 more inches of length.

That's what she said.

Going to take some measurements on mine, it may fit.

It is like throwing a hotdog down a hallway... it will fit.

I need a filter for my jwt pop but I don't think I have room for that :X