Thread: making a g20 open diff axle a lsd axle?

can i just take the part that goes into the lsd trans an swap it on the stock g20 axle so that i can put a lsd trans in?

driverside lsd axles are shorter.

So the actual shaft is shorter? So if I swapped that inner piece it would be to long?

Are G20t axles hard to come by?

to make a lsd axle for a g20 you need a b13 short side inner and shaft.

use the g20 outer/

the procedure is easy, you need a big hammer gloves and some greese with good boots.

take the b13/b14 axle with a big hammer and hit off the outer (the part that goes in the hub) do the same on your g20 axle. take the g20 outer and slide it on the splines and slam it over the circlip. Use the nut on the threads if your going to slam it on the ground so you dont damage the threads. Say hello to your new axle

i been doing this for years with no problems because no autopart store ever has my axle

does the axle have to be a b13/14 lsd axle to start with?

or could i get a ga16 axle, swap the lsd end that goes into the transmission and the g20 outter ?

I'm pretty sure the outer part of the axle's are the same with the ga and sr's... Not 100% though

I've got some ga axles in the garage, if you want to post some pics of the outers of the sr's I'll post some of the ga's and we'll comparo.

ga is a non lsd longer axle. a b13/b14 LSD axle shaft may work(outer cv joint is different).

awesome, well i know i can get se-r axles we'll see bout the g20 axle..

thanks guys

...