Thread: Blower vent block off?

I used that high temp reflective tape to cover from both sides.....weighs sweet f all

I have done that with a few holes, was thinking about it for this one, seems large though

Hey bro. I don't remember what it looks like on a b14, and I'm too lazy to go to th garage right now haha. But check with BORNGEARHEAD he had like OEM rubber covers that he put in his NX2000. I remember admiring them years ago. You can see them in this photo.

Will, use some sort of epoxy and a piece of thin aluminum, the strongest shit you can get is called panel bonding adheasive, places like carquest and autobody paint supply places should sell it.. it takes about 8 - 12 hours to dry, I'd put it on the inside, IIRC its flatter than the outside and easier to get to...Make sure and use sheetmetal screws to hold it as tight as possible while its drying, and probly have some small stiff brushes near by to smooth it all out.

Thanks guys

Hey Will, long time no talk buddy. Hows the B14 doing? I ran my old b14 without a blower in the rain quite a few times and there was no wetness inside the cabin, ever.

b14 is looking mighty dull and burly, lol. I think the wetness may have something to do with the lack of cowling also... I need some new push in clips... or maybe it's just how much I turn her on, hard to say

Haha, i guess my car wasn't into me.

Look on the bright side, atleast a tree didn't fall on yours.....